Upgrade Instructions Homepage
Printable Files
Extruder
Wires
So I want to say the upgrade went well, but there are a few caveats.
-
Some of the dampeners on the M3 screws didn’t make it into the upgrade… I hope that’s OK.
-
There’s no clear channel for cable management
-
The instructions don’t specify which screws should be used.
-
The magnets on the side pieces the fan ducts stick to, popped right out while trying to install the fan ducts. I had to superglue a few of them back in. (we’re up to 5, there are 8) so I’m concerned my now magnetically mounted fan ducts will fly off during a print and my printer will be doing kung fu, swinging the fan ducts like nunchucks.
-
The choice to user superglue has me bothered. The magnets and metal bars keep popping out respectively. I’m probably going to use the fiber laser to scuff the bars if they come out again.
